- Abstract Product Id
- Concrete Product Id
The FOX Crush Washer SS 10mm shock bushing set fits all FOX shock types with 15 x 12.7 mm rear shock eyelet and replaces the original bushings.
The durable built-in bushings are made of special plastic that reduces friction and additionally increases durability. They are mounted on either side on the stainless steel hollow pin and protected from contamination by a sealing ring on each side.
The special Crush Washer spacers ensure an optimum fitting accuracy of the installation dimension and also often allow compensation for a little too much play in the shock mount.
• 7-piece shock bushing set
• Crush washer for an exact fit
• Suitable for all FOX shock absorber types with 15 x 12.7 mm shock eyelet
• For better response and less wear
• Centre shaft/hollow pin in stainless steel design
• Modern plastics reduce friction
• O-rings and the box design keep dirt and mud out
• Material: polymer, steel, rubber
• Dimensions rear shock eyelet: 15 x 12.7 mm
• For damper installation dimension: 30.0 x 10 mm
In the box:
• 1 stainless steel hollow pin
• 2 IGUS sliding bushes
• 2 O-ring seals
• 2 spacers
• 2 spacer washers
Two shock bushing sets are required for a complete replacement on one shock.
On models prior to 2013, the red plain bearing must be pressed out before assembly!
- Manufacturer`s ref.: