innobike 105 High Tech Chain Fluid Lubricating Spray

The 4-in-1 solution for your chain: The 105 High Tech chain lube by innobike cleans, dissolves dirt, lubricates and protects in one step. The fully synthetic chain lube is quick and easy to apply, has a noticeably better lubricating performance than mineral oil and is enriched with active substances for a gentle cleaning of the chain.
innobike 105 penetrates deeply into the chain where it develops its full power. Dirt particles are dissolved and removed. The solvent contained evaporates after six to eight hours, leaving your chain free from dirt. A thin protective film remains on the chain to ensure smooth running and protect the chain from the elements and dirt. Ideal for use directly after the tour. In this way, you can keep your chain perfectly protected even after rainy rides and make it ready for your next tour.

Details:
• Chain lube and chain cleaner in one
• Penetrates deeply int the chain and infiltrates moisture
• Detergent substances reliably dissolve dirt, rust and resin
• Cleans gently: dirt particles are simply rinsed out
• Leaves a thin, highly resilient lubricating film
• Non-sticky, non-greasy for low dirt adhesion
• Also cleans, protects and lubricates other moving parts on the bike (rear derailleur pivots, Bowden cables, clipless pedals etc.)

Technical details:
• Let it work for: 6-8 hours
• Application cycle: approx. 150-300 km (depending on use and weather conditions)
• Type of application: spray (aerosol can)

Product properties (manufacturer's own scale):
• Cleaning: 3 out of 3
• Lubrication performance: 2 out of 3
• Protection: 2 out of 3

Available in:
• 100 ml spray
• 300 ml spray
Please indicate your choice.

In the box:
• 1 innobike 105 High Tech chain fluid


Tip:
Before use, place a piece of cardboard or similar under the drivetrain. Move the chain to the smallest sprocket and apply the spray directly to the chain. Turn the pedal crank backwards while applying the lube evenly on the chain until the innobike 105 chain fluid drips out of the chain links. Wait for approx. 15 to 20 minutes until all resin has been dissolved and rinsed out. Repeat the process if the chain is heavily contaminated. Leave for six to eight hours until the solvent has evaporated. What remains is a long-lasting, non-sticky, lubricating protective film.
For precise application and to avoid spray mist, we recommend you to use the proper innobike brush top (prod. code: 1487747), which at the same time allows for additional mechanical cleaning.

ATTENTION:
Avoid contact with brakes of any kind; loss of braking force possible!


Hazard and precautionary statements:
Extremely flammable aerosol. Pressurised container. May burst if heated. Keep out of reach of children. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Dispose of contents/container in accordance with local, regional regulations.







Manufacturer: Innotech Vertriebs GmbH, Junkersstraße 16, 93055 Regensburg, Germany, www.inno-bike.com